Mike
from
United Kingdom
asks
Can this be use with timer on the socket?
|
Electrical World Replies:
|
Hello, Yes this comes fitted with a plug and can be used this way. Alot of people use it with this timer plug: https://www.electricalworld.com/en/Timeguard-24-Hour-Compact-Plug-In-Time-Controller/m-3909.aspx
|
Brett
from
United Kingdom
asks
hi i need to heat the inside of a wooden insulated box 600mm x 600mm x 800 mm tall insulated with celertex i need it to be a constant 20 to 22 degrees i am castin resin and need it to cure over the winter will the 40W one do that or will i need 2 can anyone help please
|
Electrical World Replies:
|
Hello,
thanks for the question. How are you intending to control the temperature? heating this space should not be an issue for the 40 watt heater but this will depend on things such as the external temperature. If the external temperature was to drop very low can i assume if the resin needs to cure you are not able to make the box really air tight ? Making it air tight would make it easier to heat but this might not work for your resin. The safe option might be to install two units, you will find they will not use much more electricity as they will heat up quicker and cut out at the desired temperature. thanks
|
Matt
from
United Kingdom
asks
Im looking to heat a fish room, garage being 16ft long by 8ft wide how many of these would i need and what size
Thanks matt
|
Electrical World Replies:
|
Hello, there are a lot of variables involved but the below link is great for workging this out : https://www.electricalworld.com/en/News/What-Size-Of-Electric-Heater-Do-I-Need/n-54.aspx
|
Lee
from
United States
asks
I'm in the U.S. and can't find tubular greenhouse heaters anywhere for our 120V grid. If I were to have these fitted with a 120V plug, would they work ok here? What do you mean by they will "draw a higher damage"?
|
Electrical World Replies:
|
Hello, these tubular heaters will work but will draw a high current .. lower the voltage higher the current. thanks
|
Eoin
from
Ireland
asks
What wattage would you recommend for an area of 10 cubic metres, no insultation, to keep a temperature of 5+ degrees? Many thanks
|
Electrical World Replies:
|
Hello, please see the following : https://www.electricalworld.com/en/News/What-Size-Of-Electric-Heater-Do-I-Need/n-54.aspx
|
Rachael
from
United Kingdom
asks
I want to heat a tortoise house (insulated shed). 1.5m x 1.5m. I need a continuous temp of 18 degrees. Is it possible to set this heater to 18 degrees or does it not reach that kind of temperature?
|
Electrical World Replies:
|
Hello, yes you can do this, best by using a wall thermostat that brings these on / off. https://www.electricalworld.com/en/Robus-White-Heating-Cooling-Indoor-Room-Thermostat/m-3151.aspx
|
Kate
from
Australia
asks
I wasn’t to find a cupboard heater that will dry wet clothes fairly quickly.
The cupboard is 1m x 2m high
Would this actually dry the clothes in a good time frame? And how many/ size would you recommend
|
Electrical World Replies:
|
Hello
we would recommend a clothes airier or dryer for this type of function
Thanks
|
Kevin
from
United Kingdom
asks
Hi I have a 10x10 summer house just installed. Would would the dimplex tubular heater be suitable to keep the damp away in winter
|
Electrical World Replies:
|
Hello
A portable dehumidifier would be more suitable for keeping damp away
Thanks
|
Brian
from
United Kingdom
asks
I am looking to keep a treadmill in my garage under a treadmill cover, is the small 40w unit suitable to keep at a constant 10 to 12 degree temperature
|
Electrical World Replies:
|
Hello
this has an adjustable thermostat control and cut out for safety
Thanks
|
Lorraine
from
United Kingdom
asks
Hello
Can I use this product inside a fitted wardrobe to reduce dampness,mold and mildew. If so, the wardrobes are approximately 1 metre by 3 metre so what wattage would you recommend?
|
Electrical World Replies:
|
Hello
these tubular heaters are not specified for this purpose I am afraid
thanks
|
Justin
from
Australia
asks
Hello, is this product safe around birds? I have 2 Cockatiels in an outdoor aviary and this year has been particularly cold. Would this be effective to heat an outdoor bird aviary?
|
Electrical World Replies:
|
Hello, With these being thermostatically controlled they could be suitable. to make them more suitable we would suggest fitting a guard. thanks
|
Dan
from
United Kingdom
asks
Hi. What is the maximum temperature the 1ft unit can reach? Main point being, could it for instance set a curtain on fire? or similar? Thanx.
|
Electrical World Replies:
|
Hello, The maximum surface temperature of these units is 85 degrees Celsius rise over ambient.thanks
|
Alex
from
United Kingdom
asks
What fuse in the plug does the 1ft 40w require
|
Electrical World Replies:
|
hello, at 40 watts you could fit a 1 amp fuse.
|
Heather
from
Australia
asks
Could you tell me can I get this item with or for an Australian plug and does it omit any light? Thx
|
Electrical World Replies:
|
Hello, this heater does not emit any light, and it isn't available with an Australian plug, but it could be re-wired by an electrician (see the instruction manual in the product description for more details), thanks
|
Mike
from
United States
asks
What voltage are these heaters designed for?
|
Electrical World Replies:
|
Hello - these heaters are designed for 230V AC - thank you for your enquiry.
|
Pat
from
United Kingdom
asks
I have a small 6 foot by 4 foot greenhouse here in North Dublin and I am looking for a greenhouse heater. A colleague suggested a 'tubular' heater as they are water/damp resistant and better than traditional methods of heating a greenhouse. I am looking for one that has a thermostat and can keep a greenhouse of this size kept over 16 degrees plus during winter.
Would this product do and what size would you recommend?
|
Electrical World Replies:
|
A Tubular heater should do this job for you pretty nicely.
The biggest one you can fit is is what i would recommend. The reason for this is that as soon as your heater will get to the required temperature (set on the side) the sooner it will cut out
|
Ronnie
from
United Kingdom
asks
Please can you describe the differences between the Tubular Heaters by Dimplex, Greenbrook and Eterna? Thanks
|
Electrical World Replies:
|
The Greenbrook and Eterna heaters are only really different by aesthetics because they are the same in the way they operate - they have an internal preset thermostat which cuts out which it gets up to temperature. The Dimplex one has the added benefit of a controllable thermostat on the end of the heater - which is pretty handy. Some people don't like the heater with the controllable thermostat because it can be altered easily; e.g., in a church or chapel, the thermostat may be moved by children.
|
Donna
from
United Kingdom
asks
I have a detached single bricked garage 5m x 5m with no insulation but it has a plywood roof/attic - I want to maintain the garage at 10C could you please advise how many of these I would need.
Thank you
|
Electrical World Replies:
|
Hello, the usual rule of thumb would be 50-60W per sq meter but with no insulation it would be wise to double this (at least). 5m x 5m = 25 square meters. This would mean 2500 - 3000 Watts. Tubular heaters are a good way to make sure you maintain a temperature, but you might require a dozen or so of the ECOT6FT heaters. Depending on what you need to protect there might be better ways to do this, such as frost heaters or similar. Thank you for your enquiry.
|
roger
from
United Kingdom
asks
Do you know how much it is to run one of these heaters per day?
|
Electrical World Replies:
|
UPDATED NOVEMBER 2022: With the price of electricity rising rapidly, this is a difficult question to answer. The answer depends on so many factors but if we take the ECOT3FT heater as an example (3 feet long with an output of 120W). Assuming continuous running (i.e., the thermostat never cuts the supply) this heater will use 2.88kWhr per day. At an example price of 34p per kWhr (November 2022) the heater will cost 98p per day to run.
|
Nicole
from
United States
asks
How many amps does this use? Thank you!
|
Electrical World Replies:
|
Hello thanks for the question, the following heaters will use the following amps (approx figure using power factor 1 at 230V):
40 watts - 0.18 amps (180 milliamps);
80 watts - 0.36 amps;
120 watts - 0.52 amps;
160 watts - 0.70 amps;
200 watts - 0.86 amps;
240 watts - 1.04 amps.
|
Simon
from
Canada
asks
Can you tell me the input voltage requirements for these. I would like to order these for use in Canada.
Thanks
|
Electrical World Replies:
|
Hi,
These tubular heaters have an input voltage requirement of 230V at 50Hz and come fitted with a UK 3-pin Plug. Our understanding is that the mains supply in Canada is 110V at 60Hz which unfortunately makes this product unsuitable for your requirements. Thank you for your enquiry.
|
Martin
from
Ireland
asks
Would it be good to heat a caravan in winter
|
Electrical World Replies:
|
Hello Martin, these heaters are designed to be fixed to a wall so the answer would depend on how you would intend to install this. I have known these to be used for this application but, if you do not want to fix these to a wall, you might instead consider a portable heater with a tilt mechanism. This would reduce the likelihood of a fire if it were to fall over. Thank you for your enquiry.
|
Sammy
from
United Kingdom
asks
Hi,
Which size would you suggest for a shed which is 1.5m x2m . It would be used on a timer in winter just to keep the chill off for our chickens in really cold weather on a night .
Also how much would it roughly cost to run per hour.
As thinking one of these would be perfect
Many thanks Sammy
|
Electrical World Replies:
|
Hello Sammy, this guide is quite good: https://www.electricalworld.com/en/News/What-Size-Of-Electric-Heater-Do-I-Need/n-54.aspx - thank you for your enquiry.
|
Alex
from
United Kingdom
asks
Is the plug a complete unit or can it be dismantled, as I need to pass the wire through a hole to reach a socket.
|
Electrical World Replies:
|
Hello Alex, for UK orders these heaters come with a standard 13A plug. This can be removed by a competent person, to allow the wire to be passed through a hole and then reattached. See the Installation Manual in the product description for more information about installation. Thank you for your enquiry.
|
Dominic
from
United Kingdom
asks
Hi. I want to use a 300mm tubular heater inside my car during the Winter to keep the condensation away and prevent damage to the interior leather and carpets. The car will also be stored inside an inflatable cover (Carcoon) Will this tubular heater be ok or do you have an alternative suggestion please? Will it be safe to use too please?
Thank you
|
Electrical World Replies:
|
Hello Dominic, we have contacted the manufacturer with your question. Their advise is that you follow the guidance in the instruction manual which can be downloaded via the product listing page or here: http://www.electricalworld.com/Images/ModelDescriptions/Dimplex-Tubular-ECOT-Installation-electricalworld.pdf - thank you for your enquiry.
|
Kurt
from
United States
asks
My desire would be to use this for heating a fermentation box. What would the maximum temperature be? Typically 38 to 42 degrees but occasionally 70-80 degrees using an external thermostat in a meter cubed insulated heat safe space is ideal.
|
Electrical World Replies:
|
Hello Kurt, the maximum surface temperature of this heater is 85°C (153°F) above ambient. Please note that these heaters run on 230V AC and may not be suitable for your local voltage in USA. Thank you for your enquiry.
|
Darin
from
United States
asks
I live in the united states. What do I need to do to use this in the U.S. with lower voltage. Ours is 120s And 15amps. I know I need a plug adapter but do I need anything else to step up the power or will it be ok?
|
Electrical World Replies:
|
Hello Darin, these will operate on 120V AC but will draw a higher current and not give the same output. Ideally you should connect them to a fused wall unit supplying 240V AC. Thank you for your enquiry.
|
